Friday, 6 April 2018

Thank you

Good afternoon everyone, welcome to my blog , today I am sharing the brand new launch from Tonic Studios launched at 10am this morning kaleidoscope  box die sets I knew you would all fall in love  with the new designs and from Jodie's face on the 10am show I think they were on warp speed zooming out the door, but I don't blame you they are stunning sets and as you can see with all the different samples the DT have come up with so versatile.
So materials needed to create this huge box are :-
Kaleidoscope  original Octagon  lid  die set
Brand new kaleidoscope  octagon die set and long side panels towering stencils die set
Craft perfect Kraft card
Craft perfect Ivory
Craft perfect Blossom Pink
Cream 280 gsm base card
Nuvo natural twine
Nuvo Crystal drops - Ivory Seashell
Basic layering octagon die set
Thank you sentiment
Little satin pink bow
This is the largest box you can make , the tallest side panels and the largest lid using the original base lid but using the brand new decorative dies I will say this box did take some time to put together as there is a lot of paper piecing but it was so worth it .

This lid has had smaller basic layering dies added to the centre and a thank you sentiment added.

All the decorative flowers added are in the brand new sets they were shaped using Tonic Studios Flower forming kit and shaped on the reverse with a ball tool on a sponge mat.
To create this box you will need to die cut the side panels  4 times so you end up with 8 panels and I would form all the crease score lines then add the decoration to each panel then stick all the panels together I prefer deluxe adhesive myself but red liner tape is also very good for this job. The same with the lid and base I would recommend decorating first and then put together if you have never made a Kaliedescope  box before the base is the same die as the lid but when you glue the base you will glue all the tabs flush so it's all a snug fit to your base when you make the lid the tabs are glued with a slight gap not huge just slightly off the flush line on all tabs this will then give you a little more room  for the lid to  be placed on the box.

Will try and post again later today don't forget there are loads of shows scheduled but keep an eye on stock levels as things are flying out ,join Jodie again at 3pm with these beautiful stunning die sets . Xx

No comments:

Post a Comment